SC with multiple HOSTs

[rickgum]

Here is my problem. I configure SC with only one HOST entry in the Helpdesk file, and everything works fine.

I have two PC's running viewer in listen mode on different ports. My router is configured to forward to the correct PC based on the port. But, when I add a second HOST entry nothing works anymore. I can't connect to either PC.

Has anyone else had this problem?

Thanks

[redge]

([HOST] config don't change between 2 solutions, only viewer and NAT/PAT router config change

• 1st solution
  
  [HOST]
  pc0
  -connect 192.168.1.100::5500 -noregistry
  
  [HOST]
  pc1
  -connect 192.168.1.101::5501 -noregistry
  
  [HOST]
  pc2
  -connect 192.168.1.102::5502 -noregistry
  
  NAT router config
  pc0 external 5500 --> internal 192.168.1.100 port 5500
  pc1 external 5501 --> internal 192.168.1.101 port 5501
  pc2 external 5502 --> internal 192.168.1.102 port 5502
  
  
  and your vncviewer -listen port
  Start... Run...
  pc0 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5500
  pc1 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5501
  pc2 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5502
• 2nd solution for viewers
  
  [HOST]
  pc0
  -connect 192.168.1.100::5500 -noregistry
  
  [HOST]
  pc1
  -connect 192.168.1.101::5501 -noregistry
  
  [HOST]
  pc2
  -connect 192.168.1.102::5502 -noregistry
  
  
  
  if you have enough network knowledge (warning)
  you can redirect port: (but some router fail with this feature or can't support PAT=Port Address Translation
  
  NAT/PAT router config
  pc0 external 5500 --> internal 192.168.1.100 port 5500
  pc1 external 5501 --> internal 192.168.1.101 port 5500
  pc2 external 5502 --> internal 192.168.1.102 port 5500
  
  
  and your vncviewer -listen port
  Start... Run...
  pc0 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5500
  pc1 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5500
  pc2 "%programfiles%\UltraVNC\vncviewer.exe" -listen 5500