How to disallow screen blanking in SC

rmoller · Post by **rmoller** » 2006-03-30 06:25

Hello,

I'm implementing SC for helpdesk support.
The fact that SC is not listening is crucial for internal sec. audit.

However during a support session it must NOT be possible for supporter to blank the screen of the server - the supportee must be observing anything done in his/her name.

I tried to configure registry at the server end, and check out command line options to winvnc.exe to no avail - the toolbar icon still manages to blank the server screen.

I can run the vncviewer with -notoolbar -nohotkeys -restricted -listen, but it would be safer to configure the server side.

TIA

Rasmus Møller

rmoller · Post by **rmoller** » 2006-04-04 13:19

Bump,

though I understand if there is a little too much activity in the forum right now...

Rasmus

redge · Post by **redge** » 2006-04-07 21:36

I think, until today, necessary to modify the source code of SC to block/allow some feature.